Biene has pins with the steel rods in them. Metric thread too, not sure if that will help on the Bechstein. I believe Jurgen is offering a number of Biene products. Andrew Anderson At 02:32 PM 4/4/2006, you wrote: >Sorry for the late response. Some days I get so caught up in the >shop I don't get to catch up with all the interesting stuff going on >here. Anyway... > >Jude, >Regarding the tumbler, I guess it's safe to say you are not keeping >them in order, or are you? >Fenton > >I've been back and forth as far as the order is concerned. When I >first started restoring agraffes I kept them in order, but when I >started using the tumbler I abandoned the order figuring that when I >installed new ones they were out of order anyway. I might try >thraeding them in order on a wier and then tumbling. If the effort >to keep order doesn't take more time than working from scratch, >it'll be worth it. > >Jude, >I've never heard of Dri-Shine. What is it? where do you get it? ect.? >As for the "Tumbler"....Yikes! Not a good way to go, IMO. That will >screw up the threads. >Joe Garrett, R.P.T. (Oregon) > >I love your process Joe. I'll have to give it a try. Dri-shine III >is the most mild medium available for the tumbler and it is made of >corn husks. I'm pretty sure that it causes no damage to the threads. >In fact I have to prep the agraffes in the blasting cabinet first >because the tumbler will not even remove lacquer and it takes 70 >hours in the tumbler to reach a mirror polish. If I find proof that >it does I will abondon this method of polishing agraffe and probably >cry.The great thing about the tumbler is that it cleans every part >of every screw, hinge etc even inside the slots, threads and holes. >I gather all my hardware and toss it in and forget about it for >three days and that beats the hours I've spent at the buffing wheel. >I ordered it through MSC but I have a catalog for the actual maker >if you're intrigued. > > >Bechstein's are fun, aren't they, with the thick agraffes up in the treble? >Paul > >Oh yeah, they're a treat! What a great agraffe though with that >hardened steel rod. I found that you have to go in order and get >them perfectly installed before you move on to the next one. I also >had much more difficulty getting them locked down in the right >position. I definitely should have kept this set in order and with >the original shims which are thinner than anything available through >Scaff or Pianotek. > >By the way are there any other options for new agraffes for other >makes. If you're going to mess around with this you're eventually >gonna be caught with a broken agraffe. I broke one on a Knabe last >year and boy was that a pain. I went fishing through piano >junkyards all over town pulling off samples. Most of these pianos >were on on their sides, crunched together. Fun. There are may >variations of threads, height and unison spacing. >Jude Reveley, RPT >Absolute Piano Restoration, LLC >Boston, Massachusetts > > -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060404/57bd4719/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC