--- Farrell <mfarrel2 at tampabay.rr.com> wrote: > I'm not sure I would be comfortable doing all that, > but that might not > matter! Well, D.L. has claimed to have done it to many, many pianos with measurable success. The only part that worries me is the 10% humidity, which I fear could crack joints. I'd better double check on that. The bolts impinging on the ribs have cauls under them , of course, to keep from ripping through the rib. > >> > ribs might be scraped clean of finish. Then, ina > > "flexed out" state, painted with super-thin CA > glue, > > whicj should impregnate the wood, making ita lot > > stiffer. > > Did the ribs loose some stiffness somewhere? How > much did/do they need? Well, I'm guessing that he cwassuggesting that for the board to go flat, the ribs must suffer some longitudinal compression, as well. If they were "stretched" into a bow again, then impregnated with some C.A. I would think that thios oud aid the crown, greatly. I have an old Knabe upright I think I'll try this on. I'll get it toa stable, low RH< measure the crown, bow out ribs and impregnate, and measure again, all de-strung, and get back to y'all. But it may bea while, so if anine wishes to "beat me to it", i invite them to try. thanks! G > > > If any of y'all want to try this before I get a > > shot at it, and report back, please do! > > I would, but I gotta sharpen my chisels and plane > blades. ;-) > > Terry Farrell > > > Thanks, > > Thump > > > __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com
This PTG archive page provided courtesy of Moy Piano Service, LLC