Hi,Bill! This is easy repair:just convert Pedal Rod to traditional wooden dowel,drill a hole on each end to match the diameter of the Balance Rail Pin,bush the Damper Lifter Rod with Key Bushing Cloth-vola!! You are done.This repair can be done in the field if you carry extra wooden dowels.I did a lot of those repairs on school pianos... Hope,it helps.. Isaac Sadigursky -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of William R. Monroe Sent: Tuesday, October 03, 2006 8:34 PM To: Pianotech Subject: Pedal Rod Insert Hola List, Anyone have one of these (or a half-dozen)? It is the insert for the top of the pedal rod in a 2000 or so Everett Studio (made by Wrightwood Enterprises, Inc. in St. Joseph, MI - so says Pierce). I've tried calling them, and can't get through ((646) 383-1918). Anyone know anything about this company, or a different contact? If you have a half dozen of these inserts, I'd be much obliged. Can't find anything like it from the suppliers..... Thanks, William R. Monroe
This PTG archive page provided courtesy of Moy Piano Service, LLC