Hi Dave, Andrew... whomover; Agreed on the relevancy bit :) It was good for a chuckle tho. I should know I've done worse ofte times enough. About the jack/knuckle alignment tho... he didnt give us which way the angle was... but noting the drop screws are all the way up and overstriking.... I'd certainly take a good look at whether or not the stack is too low. If I had to hazard a guess I'd say he probably sees the jack angled inwards and the shanks fairly high off their cushions... assuming he went with 10 mm dip and reasonble amount of aftertouch. He didnt say but I suppose the let off screws are about as high as they can get as well. Always hard to say tho with what we have so far. Cheers RicB ---- Missed that, I guess. Not really relevant to my comments which still stand as far as what to check. Poor jack/knuckle alignment suggests the spread is off. I suppose a four year history on the piano will be very telling...you go RB! David Love davidlovepianos at comcast.net www.davidlovepianos.com
This PTG archive page provided courtesy of Moy Piano Service, LLC