That sure seems odd. I don't think I normally see them vary by more than one or two millimeters. If you want a top job, I'd sure consider replacing them - doesn't take too long. Terry Farrell ----- Original Message ----- > I'm looking at rebushing keys on a piano and I'm up against pin sizing > inconsistencies. The center rail pin size was consistent on the few > samples I checked. The front rail pin size varied 5 thousandths when > checking just six pins. Is this type of inconsistency typical for front > rail pins or would I be saving myself a lot of grief by replacing all of > them? > > Andrew Anderson >
This PTG archive page provided courtesy of Moy Piano Service, LLC