Hi John, Here's a PDF of the template if you want to make one. Basically, the rack consists of three of these plates, through which you run four lengths of 3/4" half round moulding. Hope it helps, William R. Monroe ----- Original Message ----- From: John Ross To: pianotech Sent: Friday, August 10, 2007 2:05 PM Subject: Damper Holder for Grand Dampers I went to the archives, looking for the damper holder. Found the article, but the picture of it doesn't come up, just a code. Does anyone have a picture of this holder, or know how I can get the picture to show? I guess that it would take too much bandwidth to have the pictures in the archive, so that is probably why it doesn't show. John M. Ross Windsor, Nova Scotia, Canada jrpiano at win.eastlink.ca -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20070810/e2b56351/attachment-0001.html -------------- next part -------------- A non-text attachment was scrubbed... Name: Hammer+Damper Rack.pdf Type: application/pdf Size: 332315 bytes Desc: not available Url : https://www.moypiano.com/ptg/pianotech.php/attachments/20070810/e2b56351/attachment-0001.pdf
This PTG archive page provided courtesy of Moy Piano Service, LLC