> What's the best method for bushing all the centers > quickly, and uniformly, please? > Don Mannino has a great class on this subject. What I do is to determine the size of pin that will be slightly larger than any of the pins in the row of flanges, determine the proper straight sided reamer for that pin size, and then go through the row, reaming the bushings for the oversize pin. Don't spend time custom fitting various pin sizes to each bushing, ie, if you have 19, 191/2, 20 sized pins in your hammer flanges, find what reaming is needed to fit a size 21 1/2 pin in there and then do all of them to that size. Odds are that the action will never be pinned again, and if it does, there are still several sizes yet to go, if needed. this procedure is not only as consistant as can be hoped for, it is economically feasible. Regards, Ed Foote RPT ************************************** Get a sneak peek of the all-new AOL at http://discover.aol.com/memed/aolcom30tour -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20070822/a50ba05b/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC