List, My last back repair was on a generic spinet -early 50's as I recall. I've often lowered pitch before pulling things together with heavy C clamps, but this piano was 100 cents + low . I set up my accutuner and checked pitch across the scale as I -SLOWLY!!! --tightened and closed the back. Easiest pitch raise ever! The thing came up right around pitch as the back closed up. . This piano had plate screws in the right places to secure the repair. I removed them and drilled through for bolts. I like to use carriage bolts with the head on the back side with washers on both sides and lock washer and nut on the front. I usually bring a few lengths of bolt and if nec. cut any protruding threads with a hack saw. File smooth and you have a neat repair without any protruding nuts on the back to scratch the wall. Then tune, tune, tune .and to answer the question the job took a few hours including a few passes to stabilize tuning. I set up follow-up tuning shortly after as we were on the cusp of a season change here in N.E. Tom Driscoll RPT ----- Original Message ----- I need to do this repair on a 46 year old Sohmer upright, model 34K. I have the procedural description found in Randy Potter's course but I'm looking for a rough estimate of the person hours involved. (Already consulted "G" Piano Works Repair Labor Guide, to no avail. But Joe, how do you like that citation?) Anyone have any ideas how long each bolt takes? the entire job? Any help/guidance would be greatly appreciated. Jim Frazee -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20070302/ef2552eb/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC