Hi, Sounds like a good solution, but should one also present it as an option. They may not want to give up the display space for pictures and decorations. Joe Goss RPT Mother Goose Tools imatunr at srvinet.com www.mothergoosetools.com ----- Original Message ----- From: "Don" <pianotuna at accesscomm.ca> To: "Pianotech List" <pianotech at ptg.org> Sent: Tuesday, May 08, 2007 7:23 AM Subject: Re: DC install problem > Hi Bob, > > Route the tube up to the top lid--train the client to lift the lid--and > pour over the floor not over the piano. > > At 09:48 PM 5/7/2007 -0700, you wrote: > >I'm installing a complete DC system on a Yamaha U1. > > > >The bottom panel doesn't have a gap between the top of > >it and the keybed. So, how is the water tank fill > >tube going to stick out? I'm thinking about using a > >dremel to make a "half hole" in the top edge of the > >bottom panel that will be big enough for the tube. > >Any better ideas? > > > >Bob Hull > > > >__________________________________________________ > >Do You Yahoo!? > >Tired of spam? Yahoo! Mail has the best spam protection around > >http://mail.yahoo.com > > > > > >-- > >No virus found in this incoming message. > >Checked by AVG Free Edition. > >Version: 7.5.467 / Virus Database: 269.6.5/792 - Release Date: 5/6/2007 > 9:01 PM > > > > > Regards, > Don Rose, B.Mus., A.M.U.S., A.MUS., R.P.T. > Non calor sed umor est qui nobis incommodat > > mailto:pianotuna at yahoo.com http://us.geocities.com/drpt1948/ > > 3004 Grant Rd. REGINA, SK, S4S 5G7 > 306-539-0716 or 1-888-29t-uner
This PTG archive page provided courtesy of Moy Piano Service, LLC