Pretty hard to make any significant difference without major grinding of the agraffes. I'd simply adjust the hammer bore assuming that the bearing is not at issue. David Love davidlovepianos at comcast.net www.davidlovepianos.com -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Farrell Sent: Thursday, May 24, 2007 6:59 AM To: Pianotech List Subject: Re: Agraffe Counterbore Tool To get my tenor string plane down to the desired elevation (that of the two top treble sections). I know I can simply adjust the hammer boring, but I wanted to get all the long bridge sections (plain wire) as close to one plane as I reasonably could. Terry Farrell ----- Original Message ----- From: David <mailto:davidlovepianos at comcast.net> Love To: 'Pianotech List' <mailto:pianotech at ptg.org> Sent: Thursday, May 24, 2007 9:26 AM Subject: RE: Agraffe Counterbore Tool What's the situation that you need to grind down the agraffes? David Love davidlovepianos at comcast.net www.davidlovepianos.com have been happy with it. But my current project needs to have all its new agraffes ground down a fair bit. I do not relish grinding all these agraffes by hand. I would love to put this thing in some slow turning machine and grind my agraffes that way. But what machine? I wish I could chuck it into my 1/2" drill press. This thing just reeks of some special purpose to the taper, etc. - what the heck is it supposed to mount in? Thanks for any ideas/input. Terry Farrell Terry Farrell Farrell Piano www.farrellpiano.com terry at farrellpiano.com -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20070524/c3960fd4/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC