I seem to remember a discussion along these lines some years back between Del, myself and Andre. Del, if I remember correctly took the position that the de-ribbed old panel could be seen more or less as a fresh panel as far as constructing a RC&S board was concerned. If that is correctly remembered... then I would think you would more or less scrap the old rib scale and design a new one. I suppose he may choose to chirp in and correct and clarify. Cheers RicB For those converting original pure compression boards to rib crowned and supported boards, how important would it be to consider the overall mass of the total rib scale of the original design versus that of the new design versus, say, simply the deflection characteristics of the new rib scale. Further, is there a way to numerically describe the desirable mass/stiffness ratio? David Love davidlovepianos at comcast.net www.davidlovepianos.com
This PTG archive page provided courtesy of Moy Piano Service, LLC