Has anyone ever tried using a machinists vise? You could lay the hammer flat and then slowly clamp down putting glue in at the last second. RU/UP -------------- Original message from Jon Page <jonpage at comcast.net>: -------------- > Some hammers have a lot of tension still and require extra strength > and holding time. That's why I use a thick CA on the molding and > white glue on the felt and clamp with Vise-Grips. CA alone wicks > into the felt too much, away from the joint, and you risk a failure. > > The white glue on the felt soaks in a little but also activates the CA > on the molding on contact and the clamp insures a good contact. > Pre-set the clamping pressure of the Vise-Grips before applying glue > to do the gluing operation in one quick motion. > -- > > Regards, > > Jon Page -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20080108/0798d77d/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC