Ron Nossaman wrote > It's easy. I make up a block by epoxying a 9mm Delignit cap on a low > density multilam maple, double drilling 1/4" and 6.8mm. No bit cooling, no > high precision setup, no problem. Very good uniformity and torque with > 7.1mm Denros out of the box - no micing. I'd like to give that a try on my next pinblock. Where do you get the 9 mm Delignit and do you use Pianotec's multi-laminate maple block ? Al Guecia
This PTG archive page provided courtesy of Moy Piano Service, LLC