> Ron~ > > I assume that means you drill the 1/4" (.250") hole to depth first for the > low density maple multilam, and then drill the 6.8mm (.268") just through > the Delignit cap? Where do you get the 9mm (3/8") cap? Do you bandsaw it > off a block of Delignit, then run it through the planer? Why epoxy? Aren't > there adequate wood glues? > > ~Kendall Ross Bean Both the 0.250" and the 6.8mm are through holes. I've written extensively about double drilling on list. Check the archives. As I replied to Al, resawn 1-1/2" Delignit (1/3), planed to 9mm. Epoxy for the gap filling qualities, mostly. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC