Re: [pianotech] let off gaugeHi Jon,You just lit up light bulbs in my mind.With my voicing tray made of aluminum tucked under the hammer tails. Ah Will Try It ASAP Joe Goss BSMusEd MMusEd RPT imatunr at srvinet.com www.mothergoosetools.com ----- Original Message ----- From: Jon Page To: pianotech at ptg.org Sent: Sunday, December 13, 2009 5:42 AM Subject: Re: [pianotech] let off gauge >Two reasons for shanks on hard surface: 1). consistency >2). you can use the sound of the shank falling back to gauge accuracy. The sound of the 'slight tick'. I have noticed all too often that the hammers are not bored evenly. So my jig will have the backs of the hammers, not the shanks, rest on the hard surface. I'm trying to think of some type of hinged apparatus which universally mounts to a hammer rail. Length is also a consideration due to the varying number of notes in the sections. -- Regards, Jon Page -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20091213/6d44476a/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC