How do you think, cutting the felt off, and reglueing, using the wires as a guide to get the position correct. I am thinking of bi-chords. Or would resurfacing the felt with a sandpaper paddle. John Ross, Windsor, Nova Scotia ----- Original Message ----- From: Joe Goss To: pianotech at ptg.org Sent: Saturday, December 19, 2009 7:33 PM Subject: [pianotech] Damper leak Hi, Yesterday I serviced a Gulbransen upright with leaky dampers. Spotting plastic damper assemblies, my usual damper bending tools were something that might have caused the 40 plus plastic to break so another method of getting the dampers to seat properly was used. I actually tried two ways and quickly discarded my wire bending pliers as a poor choice in favor of ???????????????? What would you have done? Joe Goss BSMusEd MMusEd RPT imatunr at srvinet.com www.mothergoosetools.com -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20091219/36cebb32/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC