Pianotek has agood tool for positioning the wire on the bridge once you have it on the hitchpin. part no. JCH-40. Getting the loop on the hitchpin ? A real bugger! Phil Frankenberg CSUChico Chico, Ca. ----- Original Message ----- From: 88man at netscape.com To: pianotech at ptg.org Sent: Tuesday, December 22, 2009 8:34 AM Subject: [pianotech] understrung bridge pins Replaced string on under area of overstrung section. Had one helluva time getting string on bridge pins in the proper configuration. Would GREATLY appreciate any tips on procedure, tools, gadgets, techniques, etc. to make this job a little easier for me. This was an old upright, and the bridge pins were located in East Jesus....hard to see, hard to get at, etc. This really kicked my old butt. Merry Christmas to all. Lance Chauvin Baton Rouge, La ------------------------------------------------------------------------------ Netscape. Just the Net You Need. -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20091222/7e4ff2ea/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC