I would say, not possible unless the assembly was set up originally with negative crown. David Love www.davidlovepianos.com -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Ron Nossaman Sent: Thursday, December 31, 2009 7:45 AM To: pianotech at ptg.org Subject: Re: [pianotech] Reversing Crown David Love wrote: > Here's a riddle though. Is it possible to have both negative crown and > negative bearing throughout the soundboard assembly? Under what > circumstances could that occur? Possible? Maybe, but I haven't seen it. Negative crown and bearing aren't that uncommon in killer octaves, but any time I've found it, there was positive bearing at least above that point. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC