I believe it was our long gone friend Newton who mentioned Flitz on the List years ago... David Ilvedson, RPT Pacifica, CA 94044 Original message From: "Paul T Williams" To: pianotech at ptg.org Received: 2/10/2009 5:29:47 AM Subject: Re: [pianotech] Damper Wire Polishing William, Great idea! It's probably faster as well. After discovering Flitz, my old Brasso can is feeling pretty left out ;>) Paul "William Monroe" <pianotech at a440piano.net> Sent by: pianotech-bounces at ptg.org 02/09/2009 06:59 PM Please respond to pianotech at ptg.org To"Pianotech List" <pianotech at ptg.org> cc Subject[pianotech] Damper Wire Polishing My wrists tend to get tired pinching cloth or scotch-brite pads over the course of 60 odd damper wires, so I'm always looking for an easier way. So, I found another use for scrap hammer felt. Just drill a small hole through the scrap, add Flitz, and polish. No squeezing, just a few glide back and forth, then a wipe off - nice and shiny. Yahoo, I'm satisfied. William R. Monroe -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20090210/cba6d96f/attachment-0001.html>
This PTG archive page provided courtesy of Moy Piano Service, LLC