Not lucky enough to have Harbor Freight up here, but I always go there when I visit. Thanks. John Ross ----- Original Message ----- From: Joe DeFazio To: pianotech at ptg.org Sent: Wednesday, February 11, 2009 7:57 PM Subject: Re: [pianotech] Screw head Hi John, Here are three cheap security bit sets from the King of Cheap (Harbor Freight): http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=91310 http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=93388 http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=95680 I don't know if the pictures are clear enough for you to tell if the bit you want might be included. The first, bigger kit lists spline bits (kit lists spline bits, kit lists spline bits, she sells seashells, whatever). Joe DeFazio Pittsburgh From: John Ross <jrpiano at win.eastlink.ca> Date: February 11, 2009 2:25:46 PM EST To: pianotech at ptg.org Subject: Re: [pianotech] Screw head Reply-To: pianotech at ptg.org I looked for a chart like that. Thanks. It doesn't seem to be any of these. I thought it was Torx, but none of my Torx fitted. I should have counted the points. They were more than the Torx, and finer. I had 8 sizes of Torx and none fitted. I just thought of what it might have been. A spline wrench might have worked. I remember them from working on electronic organs, but the organ ones were smaller. John Ross ----- Original Message ----- -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20090211/6abfd02b/attachment.html>
This PTG archive page provided courtesy of Moy Piano Service, LLC