> Greetings,
> >>Somebody clever out there should be able to design and make a two-step
> reamer.
> The first inch or so would be slightly undersized and non-cutting, to allow
> for aligning the reamer, then the second step of the reamer would do the
> cutting.<<
>
I posted to this question several years ago. It is simple to make a
reamer out of a drill bit, simply grind away the edges of the leading cutting
edges for about 3/4". That allows the alignment, and the edges will do the
reaming/cutting as the bit is pushed on farther in.
regards,
Ed Foote RPT
http://www.uk-piano.org/edfoote/index.html
**************
A Good Credit Score is 700 or Above. See yours in just 2 easy
steps!
(http://pr.atwola.com/promoclk/100000075x1215855013x1201028747/aol?redir=http://www.freecreditreport.com/pm/default.aspx?sc=668072%26hmpgID=62%26bcd=De
cemailfooterNO62)
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20090112/2d032418/attachment.html>
This PTG archive page provided courtesy of Moy Piano Service, LLC