Apologies, I stand corrected. David Love www.davidlovepianos.com From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Marcel Carey Sent: Saturday, May 02, 2009 7:23 AM To: Pianotech List Subject: Re: [pianotech] Renner hammer boring jig David, I hope you will allow me to disagree. On my Renner hammer boring jig the rake is adjustable. Marcel Carey, RPT¸ Sherbrooke, QC > From: davidlovepianos at comcast.net > To: pianotech at ptg.org > Date: Sat, 2 May 2009 07:01:10 -0700 > Subject: Re: [pianotech] Renner hammer boring jig > > It will bore vertical as well as grand hammers. There is a rake on some > grand hammers as well. The rake angle is achieved by changing the angle of > the drill press platform. If you are using a small drill press with a fixed > platform you have to shim up one side of the boring jig. The rake angle is > not adjustable on the jig itself. > > David Love > www.davidlovepianos.com > > > -----Original Message----- > From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf > Of Mark Dierauf > Sent: Saturday, May 02, 2009 6:32 AM > To: Pianotech > Subject: [pianotech] Renner hammer boring jig > > Does anybody know if this jig will bore vertical hammers as well as > grands? I'm particularly wondering if it is capable of boring the > extreme rake angle found on the old S&S uprights. Thanks, > > - Mark > > > > _____ Naviguez plus vite avec Internet Explorer 8 Ici. <http://go.microsoft.com/?linkid=9655263> -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20090502/cf28227a/attachment.html>
This PTG archive page provided courtesy of Moy Piano Service, LLC