----- This is a forwarded message ---------------------------------------- From: "David Ilvedson" <ilvey at sbcglobal.net> To: pianotech at ptg.org Received: 5/3/2009 12:08:11 AM Subject: Re: [pianotech] Renner hammer boring jig Marco, There must be some mistake? That looks just like my cappuccino maker... '-] David Ilvedson, RPT Pacifica, CA 94044 ----- Original message ---------------------------------------- From: "piano workshop" <info at pianoworkshopny.com> To: pianotech at ptg.org Received: 5/2/2009 10:01:35 AM Subject: Re: [pianotech] Renner hammer boring jig >This is the right boring machine ever...for my opinion. >It's expensive but do is job accurately. >These machine its Made in Italy but sold by Jahn - Germany. >I work with it more than 10 years without any problem. >Easy to set easy to use. >Marco De Lellis >Piano Workshop Inc. >PTG - Registered Piano Technician >21-05 31st. Avenue >Astoria New York, 11106 >USA >tel. 001 212 575 4949 >tel. 001 718 956 3110 >www.pianoworkshopny.com >info at pianoworkshopny.com > >-----Original Message----- >From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf >Of Mark Dierauf >Sent: Saturday, May 02, 2009 9:32 AM >To: Pianotech >Subject: [pianotech] Renner hammer boring jig >Does anybody know if this jig will bore vertical hammers as well as >grands? I'm particularly wondering if it is capable of boring the >extreme rake angle found on the old S&S uprights. Thanks, >- Mark
This PTG archive page provided courtesy of Moy Piano Service, LLC