Bruce Dornfields writeup was very helpful. ----- Original Message ----- From: paul bruesch To: pianotech at ptg.org Sent: Monday, November 02, 2009 8:01 PM Subject: Re: [pianotech] YC Action Brackets One would think that they (YC) would know what size to ship based on the make/model/serial# that you have to provide them. There was an excellent writeup by Bruce Dornfeld here ==> http://bit.ly/34qt6s You can also email/fax your invoice to YC... or at least you could earlier this year. Paul Bruesch Stillwater, MN On Mon, Nov 2, 2009 at 6:01 PM, Carlos Ralon <ceralon at comcast.net> wrote: I must have been lucky! After many many years I just got my 1st YC bracket failure. I called John Chang at YC. The model is a C185 at least 15 years or older. Did I just read that we need to take measurements of the old brackets before ordering? What good would the defective measurements be if they are distorted? John said the brackets are backordered, due in early November. Any tips besides the screw length would be appreciated. Carlos Ralon, RPT -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20091103/2700643d/attachment-0001.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC