Hi Michael, Yes, but you never can tell when you might find yourself confronted with with MORE than one hammer at a time... ;-) Alan Eder -----Original Message----- From: Michael Staples <mastaples at gmail.com> To: pianotech at ptg.org Sent: Mon, Aug 30, 2010 10:07 am Subject: [pianotech] Regulation sequence advice sought Al, I don't think hammer travelling and burning apply to a single note action model (action models are funny little creatures when compared to real pianos) because there are no other hammers/shanks to compare to the one hammer. Looking forward to your future comments, MS ***************************** Michael, If the dampers are out, I always align the hammer and rough fit them to the strings before I install the dampers. Makes it a lot easier to see and line up. I don't see anything about traveling and burning the hammers in your procedure. There are other changes I would make, but I just took a lunch break and I'm right in the middle of regulating an action. I'll look it over later tonight. Al - High Point, NC -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100830/014837eb/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC