Why do you need to remove the key rail to clean the keybed? Terry Farrell On Feb 1, 2010, at 4:35 PM, Clayton Bean's Piano Biz wrote: > Gentlemen: > > I have a customer that has a Wurlitzer spinet, SN 212659, 1941, > that has a 1.5 – 2” wide key rail that I can’t remove. > Need to know how by March 1, 2010 so that I can Clean the keys and > keybed. > > The rail slides backwards towards the spinet action on 2 inset cut- > outs in the piano case itself. > It reaches a stop after about 3-5” of travel and goes no further. > Trying to slide it back at an angle doesn’t help – not enough room > to pop out an end. > Lifting it up in the middle allows some bending but I don’t think > it’s too rigid to free it without snapping the rail in half. > > Would appreciate any solution you might have. > > Thank you, > > Clay Feb 1, 2010 -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100201/d5f9b3e5/attachment-0001.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC