Jon sent the original class handout with all of the diagrams. All expained now. Just didn't use those terms.<G> Enclosing the handout. I hope it goes thru. Regards and Thanks, Joe Joe Garrett, R.P.T. (Oregon) Captain, Tool Police Squares R I ----- Original Message ----- From: David Love To: joegarrett at earthlink.net;pianotech at ptg.org Sent: 1/5/10 2:48:10 PM Subject: RE: [pianotech] Action Ratios Has to do with where the energy comes from and goes just to be sure youre being consistent with the ratio orientation. Key in is the distance from key front to balance rail, key out is balance rail to capstan contact; wippen in is capstan to wippen center, out is wippen center to knuckle contact point (balancier); shank in is flange center to knuckle contact and out is knuckle to tip of hammer or shank hammer center line (I see it done both ways and Im not really sure why one over the other). David Love www.davidlovepianos.com From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Joseph Garrett Sent: Tuesday, January 05, 2010 2:00 PM To: pianotech Subject: Re: [pianotech] Action Ratios David Love submitted a formula: " (keyout/key in) x (wippen out/wippen in) x (shank out/shank in) = (blow distance - letoff)/(key dip-aftertouch)" David, Please explain the Keyout/keyin, wippenin/wippenout and shankout/shankin terms. Either I've been sleeping too much lately or those are terms I've never encountered. (Probably the former.<G> Regards, Joe Joe Garrett, R.P.T. (Oregon) Captain, Tool Police Squares R I -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100105/c9fae1e8/attachment-0001.htm> -------------- next part -------------- A non-text attachment was scrubbed... Name: Action Ratio.pdf Type: application/pdf Size: 108097 bytes Desc: Action Ratio.pdf URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100105/c9fae1e8/attachment-0001.pdf>
This PTG archive page provided courtesy of Moy Piano Service, LLC