Claude Harding wrote: > Thanks, Ron, Mike, & Dave, > I thought about making a replacement. Only one part gives me pause, > because I don't do a lot of router work. > The groove that holds the pedal pins has to be just the right size and > depth, and also aligned perfectly in the top and bottom pieces. That is the > part that concerns me. Guess it's time for me to move forward in my > woodworking skills. Wish me luck. > Thanks. > Claude Harding Thin blade in the table saw, kerf both pieces. clamp together, drill screw holes, and run a drill the right size for the pedal pin through the matched kerfs (guides). Ta-da! Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC