Only I have never seen the Brass Butt Plates in Kimball's, only the brass rail. Could be the cabinet was made by Kimball, and then someone else purchased parts elsewhere and finished the product. Ken Gerler ----- Original Message ----- From: paul bruesch To: pianotech at ptg.org Sent: Tuesday, June 08, 2010 1:52 PM Subject: Re: [pianotech] Unknown Old Upright Mfr I believe they're fine there... they just can't be pounded in any farther. Paul Bruesch Stillwater, MN On Tue, Jun 8, 2010 at 1:47 PM, Terry Farrell <mfarrel2 at tampabay.rr.com> wrote: I do realize that the coils are about as close to the pinblock as possible And you'd prefer them where? Terry Farrell -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100608/212f47ff/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC