Les, I'm not real fond of the "Mc"...whatevers. Tried them didn't care for them. Same with the Pianotec lubes. Mostly don't like the philosophy that goes along with them.<G> Joe Joe Garrett, R.P.T. (Oregon) Captain, Tool Police Squares R I ----- Original Message ----- From: Leslie Bartlett To: joegarrett at earthlink.net;pianotech at ptg.org Sent: 6/13/10 12:34:58 PM Subject: RE: [pianotech] re. Tuning Failure What about using McLube? Les Bartlett Houston What am I missing?" Floyd, Two that I can think of: 1. lubricate the under felt above the pressure bar as well as the pressure bar/capo/agraffes, with LPS-1. Spray some in the cap and apply with a paint brush. It will disapate w/in a few weeks and will not collect dust. 2. check pinblock for separations and tighten ALL bolts. It's obvious that the case is "racking". (at least to me<G>) Hope that helps. Joe Joe Garrett, R.P.T. (Oregon) Captain, Tool Police Squares R I -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100613/faabcae4/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC