Nicholas Gravagne wrote: > Trimming and / or sanding off the hammer shank (tube) stubs after the > hammer glue has dried creates a black powder, some of which migrates > into the hollow tube only to escape later on to your nice, clean > backchecks. Break up the fibrous material in the tubes with a wire and > vacuum out, or else allow the shanks to hang vertical and shake-'n-tap > the powder out. I once asked Bruce if anyone had complained about the open shank ends whistling. Got a laugh and a negative. Too bad. Could have marketed a third tuned "duplex". <G> Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC