As promised earlier, some pictures of better designs than the Yamaha. Here the rail assembly just rests on the trapwork. All you do is remove the rail from the locating holes in the gable ends. No tools, nothing. I have seen a similar type where there is no rubber stop ( the upper one) and the rail assembly just flips over 180 degrees. No tools, nothing. In the picture below, the whole rail assembly is disengaged by shifting it to the right. No tools, nothing. Ruffler Male (sent by my gramophone.....click scratch click) -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100518/8696a774/attachment-0001.htm> -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: image/jpeg Size: 107344 bytes Desc: not available URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100518/8696a774/attachment-0003.jpeg> -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: image/jpeg Size: 106167 bytes Desc: not available URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100518/8696a774/attachment-0004.jpeg> -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: image/jpeg Size: 56277 bytes Desc: not available URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100518/8696a774/attachment-0005.jpeg>
This PTG archive page provided courtesy of Moy Piano Service, LLC