Hi,Bill! Tapered Drills can be found in WOODWORKERS Supply Catalog in section of SCREWMATES 1-800-645-9292. or Woodworker. com.. Good luck! Isaac On May 22, 2010, at 9:17 AM, Bill Costanzo wrote: > Thanks for all the responses, even the attempts at bridal humor. > > I think I’ll try careful drilling first, and if that fails I may be > forced to use clip-ons. > > Isaac, would you be kind enough to explain how to make a tapered > drill bit? > > Thank you > Bill Costanzo > > > > From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] > On Behalf Of Bill Costanzo > Sent: Thursday, May 20, 2010 12:06 PM > To: Pianotech > Subject: [pianotech] Bridal Straps > > I have a question about a Heinzman upright I am reconditioning. > (mouse infested, but not too bad) It also has had some previous > reconditioning including restringing and new hammers (on old shanks > and butts, unfortunately). The straps had also been replaced but > need to be replaced again. The problem is that the corks have been > glued in with industrial strength glue and won’t come out. I can cut > the strap flush with the cork and use clip-ons, or I can cut the > bottoms off the catchers and use clip-ons. I’m interested in knowing > what anyone else has done in this situation and opinions about which > way will yield the better looking results. I should mention that I > broke one of the catchers at the cork hole already so I’m leaning > towards removing the bottom half of the catcher. Also what tool > would you use to cut with, side cutters, shank nippers? > > Thanks > Bill Costanzo -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100522/1400b170/attachment-0001.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC