[pianotech] Fwd: vacuum press pinblock

[Dale Erwin]

   Hi Joe 
    again as I said I used a scrap piece off the block and what the new picture shows is the uniformity of the top cap on the entire block. 





 Dale, 
> All of the substrates look really good. However, what's with the 
> inconsistant top multi-lam? That would be were one would want the best 
> consistency, I should think.??? 
 Again....  This was a small piece that came off the angled cut and I was trying to trim it a bit to size on the band saw for a decent picture which...didn't work.  The top cap is (uniformly) 7 mm
 And it isn't sloppy. Come on  now.... glasses on.... microscope off.  I'm done














-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://ptg.org/pipermail/pianotech.php/attachments/20101107/9f88737a/attachment-0001.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/jpeg
Size: 166533 bytes
Desc: not available
URL: <http://ptg.org/pipermail/pianotech.php/attachments/20101107/9f88737a/attachment-0002.jpeg>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Stwy_B_hybrid_block.JPG
Type: image/jpeg
Size: 166533 bytes
Desc: not available
URL: <http://ptg.org/pipermail/pianotech.php/attachments/20101107/9f88737a/attachment-0003.jpeg>