On 11/29/2011 3:49 AM, Joe Wiencek wrote: > Hello list, I've been reading with great interest about the recent > articles in the Journal about treating bridges with thin epoxy. I am > trying to imagine an epoxy that's thin enough to be put on the bridge > cap without it adding material. Is there a very thin viscosity epoxy > on the market that's being used for this, or the possibility of > thinning epoxy with lacquer thinner or some other solvent? Thanks for > any input. It's put in the holes to solidify the mounting of the pins, rather than on the cap. It doesn't take anything exotic, West system works fine. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC