So what would be rescaling? Moving the bridges as well? Dean Dean W May (812) 235-5272 voice and text PianoRebuilders.com (888) DEAN-MAY Terre Haute IN 47802 -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Joseph Garrett Sent: Saturday, January 07, 2012 5:42 PM To: pianotech Subject: Re: [pianotech] string scale Matthew asked: "Does anyone know where I can find (or happen to have)?a string scale for an Ivers & Pond 1924 Grand, Scale 73?? It is not in the "Guide to Stringing" by Travis.? Any help appreciated, thanks so much!" Matthew, (with 2 t's<G>) Sigh. This question just keeps coming back to the surface. It assumes that what is in the book, etc. is correct! My experience says different. The best way to do it, is to take all the measurements of the existing speaking lengths and all the wire sizes. The most important part is to take the BASS measurements. This is the main thing that is wrong with the travis book. It only addresses the plain wire part of the scale! THEN, techs just send the bass strings off to who knows and assume that the scale was the best that it can be and the string maker is going to duplicate them ....exactly. Too many wrong assumptions to even think about in one sentence! I strongly urge all to do the"math" or do all the measurements and send the data to someone, like myself, that will analyze the existing scale and then make the changes to give the optimum. If you are computer literate you can do this. Ya really don't have to be some kind of math whiz kid!<G> The formulae are available to all. Most techs make a spread sheet for this. There are two ready made programs, out there, that will get you up and running faster. They are from Mark Gallant, Assoc., Portland Chapter or Tremaine Parsons, R.P.T., Sacramento Chapter. Yes, it takes a goodly amount of time to do all of this, but if you are "re..whatevering", you need to have this skill!! Otherwise, leave the "re..whatevering" to those that can/do.<G> BTW, this is NOT RESCALING! (oooohhh the dreaded word!<G>) This is simply taking given data, knowing the basic intent of the designer, eliminating factory snafus and making it optimum for the given perameters available. Once you've done this it's a must forever more. Best Regards, Joe Joe Garrett, R.P.T. Captain of the Tool Police Squares R I
This PTG archive page provided courtesy of Moy Piano Service, LLC