[pianotech] Finish Repair Question - Should be Case Repair Question

[David Love]

Actually, fitting a piece of wood would probably require the most work as I
see it.  The section is not quite precisely cut at present and would have to
be squared and leveled.  The wood would have to be cut to size very closely
as access to do leveling after is somewhat limited would be the slowest and
most difficult to sand level being made of wood.  The ends would still have
to be filled and blended afterwards and then you'd have three different
surface materials to match and blend.  

Ruth Phillips just sent me a sequence of photos that utilize her wood
rebuilder product which I'm tempted to use.  Thank you all for your input.

David Love
www.davidlovepianos.com


-----Original Message-----
From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf
Of Encore Pianos
Sent: Wednesday, June 06, 2012 5:39 AM
To: pianotech at ptg.org
Subject: Re: [pianotech] Finish Repair Question - Should be Case Repair
Question

Thank you for making my point in the fewest words possible.  :-)

Will

-----Original Message-----
From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf
Of Jon Page
Sent: Wednesday, June 06, 2012 6:48 AM
To: pianotech at ptg.org
Subject: Re: [pianotech] Finish Repair Question - Should be Case Repair
Question

You could have fitted a piece of wood in there and have been done with it
already.

--
Regards,

Jon Page