Begin forwarded message: > From: Isaac Sadigursky <isaacspianoservice at gmail.com> > Date: September 7, 2012 8:53:36 PM PDT > To: Isaac Sadigursky <irs.pianos at earthlink.net> > Subject: Fwd: [pianotech] Repair to console music desk > > > > Begin forwarded message: > >> From: pianotech-owner at ptg.org >> Date: September 7, 2012 8:40:16 PM PDT >> To: isaacspianoservice at gmail.com >> Subject: Re: [pianotech] Repair to console music desk >> >> Your post to the pianotech at ptg.org mailing list was automatically >> rejected. This was done by a program, not by a human, so please >> don't >> take it personally or think that someone read your post and didn't >> like it. >> >> The most common reason this happens is that the email address you >> posted from was not found to be a subscriber of the pianotech list. >> Perhaps you subscribed with a different address than the address you >> used to post, or perhaps you tried to post without being subscribed? >> >> Contact admin at ptg.org if you need help resolving this issue. >> >> >> From: Isaac Sadigursky <isaacspianoservice at gmail.com> >> Date: September 7, 2012 8:24:18 PM PDT >> To: pianotech at ptg.org >> Subject: Re: [pianotech] Repair to console music desk >> >> >> Hi, Jurgen! >> I will save you a call... >> I will bring my set-up for repairing Music Racks. >> The main item is; >> Samick's L-Shaped Brass Bracket installed on each end. Ramsey >> Corp. in New York makes them,but Schaff is not selling them [???] >> I f the wood is badly damaged-I cut-off about 1/8" from the Buttom >> [And God will Understand].All new hardware goes into the fresh wood. >> I also have about 3 dozen of Music racks salvaged from junked pianos. >> Joe! >> Send me the picture for color and LENGHT of the rack. >> On a few instances,if matching rack was longer or shorter; >> The STUDS HOLES can be plugged with Hammer Shank and new holes >> easely postioned and drilled.. >> Call me,if you need any clarification. >> But for you,Jurgen,I will bring my shop repair set-up to Phoenix. >> Best to all . >> Isaac >> >> On Sep 6, 2012, at 10:57 PM, Jurgen Goering wrote: >> >>> What is the "best" fix for a music desk on a console or studio >>> upright which has been damaged at the screw pivot point? Its >>> funny how one good smack on the music desk, or a mere cinching up >>> of ratchet strap in the course of a move can break the wood at the >>> screw [tongue in cheek here]. >>> So what is the most economical and fast in-home repair (while I >>> tune)? Five minute epoxy? Tightbond with a small clamp? >>> I was thinking of calling Isaac Sadigursky but I'll try this list >>> first... see if anyone else knows.... :^) >>> regards, >>> Jurgen Goering >>> >>> >>> >>> >>> >>> >> >> >> > -------------- next part -------------- An HTML attachment was scrubbed... URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20120907/fb8d82b6/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC