[pianotech] Brass rail/plate Threads?

[Ron Nossaman]

On 2/21/2013 5:01 PM, John Ross wrote:
> Where is this source of rare taps.

www.victornet.com Write it down and tape it to the computer. This is a 
good one.

> I have often wanted to tap damaged holes or redo some plates.
> Schaff just has plates tapped to fit those too long wrong headed screws.
> Anyone found a source of the 'proper' screws.
> APSCO used to have them, or was it Tuners Supply?

Don't know. I have a slew of screws and repair plates and such, but 
haven't used one in many years so I haven't had to try to figure it out.
Ron N