Ron said: "I worked out the numbers, and these are 3-56, a standard size" Ron, For all practical purposes, yes that is what my gauges tell me.....er sorta.<G> Honestly, it did not occur to me to "do the math" conversion!<G> If the 4.5mm threaded hole was more than 1/2 inch, it would start to bind with a 3-56. At least that's what my gauges are telling me.<G> However, in this application, where the threaded material is less than 1/16", it's not an issue. There still remains, tho, what the heck all of those NOS plates/screws, I have, are? As near as I can calculate, the thread count is around 52 tpi! I don't know of any "standard" that fills that bill. Go figger. Thanks for your help and enlightenment.<G> Best, Joe Joe Garrett, R.P.T. Captain of the Tool Police Squares R I http://gpianoworks.com/
This PTG archive page provided courtesy of Moy Piano Service, LLC