<HTML style="FONT-SIZE: x-small; FONT-FAMILY: MS Sans=
Serif"><HEAD>
<META http-equiv=Content-Type content="text/html;=
charset=iso-8859-1">
<META content="MSHTML 6.00.2900.2722" name=GENERATOR>
<STYLE></STYLE>
</HEAD>
<BODY bgColor=#ffffff>Hmmm....it is smaller in diameter than the=
birdseye...Hmmm?<BR><BR>David I.<BR><BR><BR><BR><BR>
<DIV style="PADDING-RIGHT: 5px; PADDING-LEFT: 5px;=
PADDING-BOTTOM: 5px; BORDER-LEFT: #000000 3px solid;=
PADDING-TOP: 5px">
<HR>
Original message<BR>From: Farrell=
<MFARREL2@TAMPABAY.RR.COM><BR>To: Pianotech=
<PIANOTECH@PTG.ORG><BR>Received: Sun, 4 Sep 2005 05:48:24=
-0400<BR>Subject: Re: Repinning Tip was Re: Steinway double=
flange fitting to butts<BR><BR>
<DIV align=left><FONT face=Arial>Hmmmm. Okay, but now how do you=
get the straight </FONT><FONT face="MS Sans Serif">piece of=
piano wire, or a smooth round burnishing tool, through=
the whole assembly, without ramming it through hard rock=
maple? Hmmmmmm???</FONT></DIV>
<DIV> </DIV>
<DIV><FONT face=Arial>FWIW, I just push the pin through without=
any guide. I pre-align by eye, sometimes wiggle just a little,=
and don't seem to have a problem getting the pin in the birdseye=
without jamming it into the wood (although I have done that=
early-on before developing an eye for=
pre-insertion-alignment).</FONT></DIV>
<DIV><FONT face=Arial></FONT> </DIV>
<DIV><FONT face=Arial>Terry Farrell</FONT></DIV>
<BLOCKQUOTE dir=ltr style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px;=
MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT:=
0px">
<DIV style="FONT: 10pt arial">----- Original Message -----=
</DIV>
<DIV><FONT face=Arial></FONT><BR></DIV>
<DIV>
<DIV>I get tired of fussing with pin, press, flange, and=
birdseye--trying to align the parts and insert the pin without=
trying to ram it through hard rock maple--so I have a=
foolproof little system. (And it works for me which proves that=
any fool can do it.)</DIV>
<DIV> </DIV>
<DIV>I run a thin, straight piece of piano wire, or a smooth=
round burnishing tool, through the whole assembly, then=
pull the wire back while guiding the pin through the first=
side of the flange and slightly into the birdseye. Then press=
the pin on through, pushing the wire or tool the rest of=
the way out. The wire/tool keeps everything aligned so the pin=
centers every time, and it's fast.</DIV>
<DIV> </DIV>
<DIV>Alan Barnard</DIV>
<DIV>
<DIV>Salem,=
Missouri</DIV></DIV></DIV></BLOCKQUOTE></DIV></BODY></HTML>