<html> <body> Cy, At 06:10 PM 12/10/04, you wrote: <blockquote type=cite class=cite cite="">Tuned a 1969 Kohler & Campber  (Samick) studio today.  Hammers going all over the place, left and right.  Tried to adjust one, and discovered each section is pinned with one giant flange pin.  How the heck do you travel these hammers?  Is heating and twisting the shanks the only option?</blockquote> Traveling and "heating & twisting" the shanks are two different things. Trave first by papering the flanges and then do your burning. Avery <blockquote type=cite class=cite cite="">--Cy Shuster-- Bluefield, WV  </blockquote></body> </html>