<HTML>In a message dated 6/13/02 5:25:38 PM Central Daylight Time, Tvak@AOL.COM writes: <BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">What I don't know is:  would putting the old wires/heads on the new levers be easy?  Would the damper wire slip into the lever like a hammer shank into a butt?  Add a little glue, and you're all done?  Or would they have to be forced in? </BLOCKQUOTE> I have never done this before. But it would seem that the wires are forced in with a machine, and probably quite tight. You might wind up bending the wires when you try to put them in, (over and above the bends in there already). Not only that, even though most of the plastic levers will probably disintegrate, some of them are going to be stubborn causing more headaches.   Again, I think you're better off bending wires. Too bad you had a bad experience before, but don't let that keep you from doing a better job this time. Who knows, you'll get so good, the next thing you know you're teaching a class on the subject, and advertising in the Journal to take on outside work. :) Wim </HTML>