<html>
At 10:06 PM 14/04/00 -0400, you wrote: <br>
<font size=2><blockquote type=cite cite>Thanks for the replys
everyone. Newton and Jon honed in on the info I was seeking.
My post was perhaps a little vague but I was looking for info on the side
cut (tapering) not the tail arcing, but that was interesting reading
too.</font><br>
<font size=3> </font></blockquote><br>
<font size=2>Hi Doug,<br>
I've still got a few drawings of the tapering jigs that I used in the KC
class, Bill Spurlock's new jig is a modified copy, but can't
taper hammers on the shank.<br>
Also better material removal happens when the cut starts from the tail,
<br>
If you give me a mailing address I'll send a copy.<br>
Roger<br>
</font><br>
<div>Roger Jolly</div>
<div>Saskatoon, Canada.</div>
<div>306-665-0213</div>
Fax 652-0505
</html>