<DIV>Dear List,</DIV>
<DIV>I'm working on a Steinway M regulation and on bedding the keyframe.&nbsp;(Not the same one I had a question on&nbsp;about a month ago.)&nbsp;I thought I had accomplished this already- but the knocking on the bass end has returned during the process of the other regulation steps.&nbsp; I'm wondering if when I regulated&nbsp;the balance rail studs it came back.&nbsp;I used the&nbsp;sliding paper method and felt good about the results.&nbsp;&nbsp;So, as I found this knocking I returned to the keybedding and I did some more sanding on the bottom of the front rail but no progress seems to be coming about - the bass end still knocks when you tap on it.&nbsp; Both ends of the frame knock when tapped, but the treble stops when you put the cheek block on, but the bass end still knocks.&nbsp; I measured the thickness of the front rail on both ends and the middle.&nbsp; Bass end is .836; middle of front rail is .881 and treble end is .850 or .860.&nbsp; I know the keybed is crowned up in the middle and the keyframe is reverse crowned.&nbsp;&nbsp; Here's my question:</DIV>
<DIV>What would you think of painting a layer of epoxy on the bottom of the bass end of the rail to thicken it rather than sanding/thinning the whole rest of the rail until that knocking went away? (The knocking begins about 1 octave from the bass end.)</DIV>
<DIV>Also, with this crowned/reverse crown between keyframe and keybed should the testing of the bedding be always done with cheek blocks screwed in?</DIV>
<DIV>One other question to drown you with - do you reflect the crowned keybed in the key leveling?&nbsp; I have heard yes and no on this.</DIV>
<DIV>Thanks.</DIV>
<DIV>Bob Hull</DIV>
<DIV>&nbsp;</DIV><p><hr SIZE=1>
Do you Yahoo!?<br>
<a href="http://us.rd.yahoo.com/search/mailsig/*http://search.yahoo.com">The New Yahoo! Search</a> - Faster. Easier. Bingo.