<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; = charset=iso-8859-1"> <META content="MSHTML 6.00.2900.2180" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial size=2>Hey Joe (ok, this was an easy joke too = make... ;-)</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Are the photos on your website = reflecting the exact size of the levelling device, or is it just for = presentation?</FONT></DIV> <DIV><FONT face=Arial size=2>Because on the photos, the levelling is = done on a sample of a keyboard (probably 2 octaves).</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>How long is the levelling edge? Can you = level the entire keyboard without moving the edge from one section of the keyboard = to another?</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>BTW, you were talking about back check leads.</FONT></DIV> <DIV><FONT face=Arial size=2>According to you, is it better to = regulate the keyboard height with the action screwed on the keyboard, and with = inserting cut(with scissors)-balance rail punchings?</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>When I have to do an entire levelling = on a grand, I put leads on the back checks and regulate the keyboard in the piano, = with my Yamaha straight edge. </FONT></DIV> <DIV><FONT face=Arial size=2>But when there are only a few = modifications to make to the levelling, I simply cut one side of the punchings I have to add = with scissors, and insert it while lifting the keys and the felt punching at = the same time.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Quentin</FONT></DIV></BODY></HTML>