<html>
<font size=3>At 05:53 PM 05/09/2001 -0500, you wrote:<br>
<blockquote type=cite cite>David<br>
I always drill through the pin bushings with the plate and pinblock in
the<br>
piano. The holes are always in line.<br>
Paul Chick</font></blockquote><br>
If you don't have the setup for drilling in the piano, you can drill the
bushings in the plate.<br>
<br>
Once the bushings are installed, remove the plate, drill from the bottom
at the angle at<br>
which the block was drilled. This will ensure a better alignment.<br>
<br>
Regards,<br>
Jon Page, piano technician<br>
Harwich Port, Cape Cod, Mass.<br>
<a href="mailto:jonpage@mediaone.net" eudora="autourl">mailto:jonpage@mediaone.net</a><br>
<font size=3><a href="http://www.stanwoodpiano.com/" eudora="autourl">http://www.stanwoodpiano.com<br>
</a></font>~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~</html>