<HTML><BODY BGCOLOR="#ffffff">In a message dated 10/23/02 7:27:12 AM Central Daylight Time, mfarrel2@tampabay.rr.com writes: <BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px"> Lots of good suggestions on centering a hole, but Ron is the only one that touched on my real concern. I like the Bolduc blocks, but I have a general concern about using them on a no-bushing plate. I was planning on using (for the first time) a Delignit block on this M&H upright. </BLOCKQUOTE> Terry you must have missed my earlier post about punching an off center hole. David Koelzer Vintage Pianos DFW</HTML>