<HTML>In a message dated 04/03/2002 4:54:04 PM Eastern Standard Time, RNossaman@KSCABLE.com writes: <BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">It's simple, Dick. You put a screwdriver in the slot and turn, the screw breaks, and that's all there is to it. I get a feeling those aren't the details you wanted though. My preference is to leave the dumb things in there (if there's room to get past them), and put a new screw right next to them. Something like a sheet rock screw, only heavier gage and longer, is available at any decent hardware store. They are roughly 73 times harder than the originals, but even so, I'd drill a pilot hole</BLOCKQUOTE> Actually these action screws are the kind with a3 inch plastic spacer between the bracket and the plate.  Don't know if I could get a drywall screw that long.</HTML>