<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> <HTML><HEAD> <META http-equiv=Content-Type content="text/html; charset=iso-8859-1"> <META content="MSHTML 6.00.2900.2802" name=GENERATOR> <STYLE></STYLE> </HEAD> <BODY bgColor=#ffffff> <DIV><FONT face=Arial size=2>Oh, crud.  It finally happened to me.  A tool went flying and made a nice chip in the big, fancy grand I was working on.  #$&%  </FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>I searched and found a nice post from Jon Page about spraying from a can into a small cup and using an artist's brush to apply the mixture.  (I went back to find the post, but couldn't find it again.  grr.)  Except, of course, I don't have a can of the original finish and will have to mix to match the color.  Sure wish I had some paint chips (so to speak) of those different colors of bronzing powders--I'm not a rebuilder so bronzing powders aren't (normally) in my inventory.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Anybody know where I could get smaller quanitites of the powders.  I googled but didn't find much.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Any suggestions?</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Thanks.</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV> <DIV><FONT face=Arial size=2>Barbara Richmond, RPT</FONT></DIV> <DIV><FONT face=Arial size=2></FONT> </DIV></BODY></HTML>